Maretron DCM100 - Direct Current (DC) Monitor for NMEA 2000 Network

Maretron's DCM100 Monitor is an advanced electronic monitoring device used to measure the voltage and current of any direct current (DC) power source or load. By connecting to the NMEA 2000 network, the DCM100 allows you to access this information on any NMEA 2000 compatible display. Examples of DC power sources that can be monitored with the DCM100 include batteries, alternators, solar panels, and wind generators. The DCM100 can also be used to monitor DC loads like inverters, windlasses, DC refrigerators, or any DC branch circuit. When the DCM100 is used to monitor batteries, sophisticated circuitry and sftware algorithms monitor battery temperature, load current, charging current, and terminal voltage to precisely compute battery state of charge, state of health, and time remaining. To measure current, the DCM100 uses an included state-of-the-art Hall effect current sensor, which simply slips over the wire so that you don't have to break connections or install connectors, as with inline shunts. The DCM100 is a key component of Maretron's N2KView vessel monitoring and control system. Meets NMEA 2000 specifications.

DCM100 Monitors:
• Battery Voltage
• Battery Current
• Ripple Voltage
• Battery Case Temperature
• State of Charge
• Time Remaining
• Charge Efficiency Factor

Accessories sold separately:
(#84190) Battery Harness w/Fuse
(#84191) 200 Amp Current Transducer w/Cable
(#84208) Ring/Under Bolt Temperature Probe