Winegard SensarPro TV Signal Meter - White

Catalog Item # 55642

Designed to work with all amplified Sensar antennas, the SensarPro replaces your current power supply and makes peaking on digital channels a breeze.

Designed to work with all Sensar antennas, the SensarPro replaces your current power supply and makes peaking on digital channels a breeze. SensarPro is an all in one product that acts as a signal meter, adjustable amplifier and wall plate power supply for your Sensar antenna.

It is ready out of the box and can be customized for specific search modes eliminating guesswork and frustration. Built in amplification can give you up to 10 dB of gain for increased performance or the ability to lower the gain when positioned near a tower. Adjustable audio feedback comes in handy when the wall plate is out of sight or reach.

High grade electronic digital tuner focuses on all digital broadcast frequencies and ignores non-TV broadcast signals to provide precise and accurate channel readings. Proudly designed, tested and built in the U.S.A.

Technical Specifications

Less than 1 lb.

Camper's Choice Rating

Reviewer rating of 4 stars based on 9 reviews (4 Based on 9 Reviews)

Add A Review

  • Ease of function (2)
  • Great design (2)
  • Fit existing amp (1)
  • I Had To Move It When I Replaced The Existing Amplifier (1)

Eases reception

by sure2rain – April 02, 2013
5 out of 5 stars

Upgraded from old style amplified connector. Install was very easy. The SensarPro does ease aiming of the antenna. Worth the cost.

Great Performance

by Wolfgang Penzel – November 01, 2011
5 out of 5 stars

Easy to install, this signal Meter Amplifier greatly improved the performce of the over-the-air antenna. The signal meter display

Works well

by Paul Bensen – April 14, 2011
5 out of 5 stars

The product works well, it is easy to operate and it mounts in the same place as the original Winegard antenna booster did. Jus

Review from Camarillo, CA

by Anonymous – August 08, 2012
5 out of 5 stars

The Winegard SensarPro TV Signal Meter works as good as advertised (maybe better). It was easy to install in place of the older

Nice Replacement for a low end antenna amplifier.

by Julian Buck – August 28, 2012
4 out of 5 stars

This meter was easy to install, using the included instructions. I was replacing an original equipment antenna amplifier / cable

by Dogbone – July 01, 2015
I have an AntennaTek antenna.
If the rooftop antenna is a 12V amplified unit, yes it is possible to use the SensarPro with said antenna. 'AntennaTek' has a batwing model that is designed and operated the same as Winegard's 'Sensar' batwing antenna. Amplified units are wired to a powered wall plate, Winegard used the same design before the 'SensarPro' where the plate had an On/Off button, output 'F' connector for TV1, and a 12V DC outlet. Wiring on the SensarPro is a little different, TV1 and TV2 coax are wired directly from the plate to the TVs or to secondary wall plate. SensarPro Install/Owner Manual
by Camping World – November 02, 2015

Related Items

You May Also Like